- 您现在的位置：买卖IC网 > Sheet目录498 > OTX-433-HH-LR8-HS (Linx Technologies Inc)XMITTER HS LNG-RANGE 433MHZ 8BTN
OTX-***-HH-LR8-HS BUTTON ASSIGNMENTS
This diagram illustrates the relationship between the button locations and
encoder data lines.
COMPLIANCE REQUIREMENTS
The OTX-***-HH-LR8-HS has been pre-certified by Linx Technologies for FCC
Part 15 and Industry Canada RSP-100 compliance. The 433.92MHz version has
also been tested for CE compliance for use in the European Union. The 315MHz
and 418MHz versions are not legal for use in Europe.
LABELING / INSTRUCTION REQUIREMENTS
The OTX-***-HH-LR8-HS Long-Range Handheld Transmitter has already been
labeled in accordance with FCC, Industry Canada, and CE regulations in effect
as of the date of this document. No further labeling of the unit is needed;
D6
D4
D2
D0
Figure 4: OTX-***-HH-LR8-HS Button Assignments
ASSEMBLY DIAGRAM
D7
D5
D3
D1
418MHz
FCC ID: OJM-OTX-XXX- LRMSA
IC: 5840A-LRMSXXXA
however, it is necessary to include the following statement in the end product’s
instruction manual or insert card for FCC compliance. Industry Canada only
requires the shaded portion. The EU does not require a statement.
INSTRUCTION TO THE USER
This device complies with Part 15 of the FCC Rules.
Operation of this device is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B
computing device, pursuant to FCC Rules. In order to maintain compliance with
FCC regulations, shielded cables must be used with this equipment. Operation
with non-approved equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned that changes and
modifications made to the equipment without the approval of manufacturer
could void the user’s authority to operate this equipment.
Figure 5: OTX-***-HH-LR8-HS Assembly
Place the above statement in the instruction manual or insert card.
Page 6
Page 7
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
OTX-ACC-RTR-32-LD
RETRACTABLE REEL 32MM
OV02655-A38A
SENSOR IMAGE CMOS 2MP 38-CSP2
OV03640-V56A-2D
SENSOR IMAGE CMOS 3MP 56-CSP2
OV05633-C48A
SENSOR IMAGE CMOS 5MP 48-CLCC
OV05642-A63A
SENSOR IMAGE SOC 5MP 63CSP3
OV07690-A20A
SENSOR IMAGE CMOS VGA 20-CSP3
OV07740-A32A
SENSOR IMAGE CMOS VGA 32-CSP3
OV08810-A67A
SENSOR IMAGE
相关代理商/技术参数
OTX-433-HH-LR8-MS
功能描述:射频模块 MS 8Button LongRange Handhld Trans 433MHz
RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm
OTX-ACC-KIT-HH-BLK
功能描述:罩类、盒类及壳类产品 HH BOOT&BELT CLIP w/ LOOP (FOR RETRO-FIT) RoHS:否 制造商:Bud Industries 产品:Boxes 外部深度:6.35 mm 外部宽度:6.35 mm 外部高度:2.56 mm NEMA 额定值: IP 等级: 材料:Acrylonitrile Butadiene Styrene (ABS) 颜色:Red
OTX-ACC-KIT-HH-GRY
功能描述:罩类、盒类及壳类产品 HH Boot&Belt Clip w/ Loop (for retro-fit)
RoHS:否 制造商:Bud Industries 产品:Boxes 外部深度:6.35 mm 外部宽度:6.35 mm 外部高度:2.56 mm NEMA 额定值: IP 等级: 材料:Acrylonitrile Butadiene Styrene (ABS) 颜色:Red
OTX-ACC-KIT-HH-OEM-B
功能描述:罩类、盒类及壳类产品 HH BOOT AND BELT CLIP WITH LOOP, BLACK BOOT, INSTALLED RoHS:否 制造商:Bud Industries 产品:Boxes 外部深度:6.35 mm 外部宽度:6.35 mm 外部高度:2.56 mm NEMA 额定值: IP 等级: 材料:Acrylonitrile Butadiene Styrene (ABS) 颜色:Red
OTX-ACC-KIT-HH-OEM-G
功能描述:罩类、盒类及壳类产品 HH BOOT AND BELT CLIP WITH LOOP, GRAY/BLACK, INSTALLED RoHS:否 制造商:Bud Industries 产品:Boxes 外部深度:6.35 mm 外部宽度:6.35 mm 外部高度:2.56 mm NEMA 额定值: IP 等级: 材料:Acrylonitrile Butadiene Styrene (ABS) 颜色:Red
OTX-ACC-LSH-8.5
功能描述:LEASH FOR OEM TRANSMITTER RoHS:是 类别:盒，外壳，支架 >> 箱 - 配件 系列:OTX 3D 型号:ESSMF.stp 标准包装:1 系列:Eclipse 附件类型:支脚 适用于相关产品:Eclipse 系列
OTX-ACC-RTR-32-LD
功能描述:RETRACTABLE REEL 32MM RoHS:是 类别:RF/IF 和 RFID >> RFID配件 系列:* 标准包装:1 系列:- 附件类型:WLAN-A 无线适配器 适用于相关产品:629-1002-ND、629-1045-ND、629-1046-ND、LRU2000 读取器 其它名称:2421.000.01.00629-1048DCF-660W
OTX-ACC-RTR-CLP-MD
制造商:Linx Technologies Inc 功能描述:Retractable 35X65 mm Black Reinforced Strap w/Rear Belt Clip Wireless Accessory 制造商:Linx Technologies Inc 功能描述:M2M ACCESSORY